The tiles installed on your walls have a limited life. They must be removed and reinstalled in some years. This changes the ambiance as well as increases the homely feel of your abode. In case you are wondering How To Tile A Wall, firstly remove the old tiles with the help of hammer and chisel. Cover all surrounding areas as well as your eyes to protect from flying debris. Try to cause minimal damage to the underlying wall as this will create good results with new tiles.

After this, mark all corners along a single line to accommodate the tiles without heavy adjustment in the corner. The next step is to apply adhesive to the wall. Using a trowel at about 60 degrees, smear adhesive in even thickness. Maintain places between tiles as you move forward. In case you need to cut tiles, use a wet tile-cutter. It is preferable to leave the tiles overnight for grouting.

Before using, colour the grout. This is the next step in how to tile a wall. If any of the edge has spacers, it needs to be removed before the grout is pushed into joints. Do not let excess grout stay on tiles for long. Remove the grout with a damp, wet sponge, wrenching in clean water. Start with the middle areas and work your way towards the corners.

The internal corners of the walls where tiles meet should be sealed with silicon sealant or mastic to make the corners waterproof and to give them a neat appearance. Additionally, masking tape can also be used before applying sealant. Carefully layer the surface with sealant keeping the pressure even with slow speed. Run along your wet fingers to allow surface to shine. On being set, remove the masking tape and polish the tiles to remove any haze.
Sharee Turner
3/16/2013 02:15:02 am

Thank you! I have been looking all over for this! Keep up the good work. This is very informative.

Reply



Leave a Reply.